Allied Telesis AT-9000 Series - Manual (Page 484)

Chapter 29: Boot Configuration File Commands
456
SHOW BOOT
Syntax
show boot
Parameter
None
Mode
Privileged Exec mode
Description
Use this command to display the name of the active boot configuration file
and the version numbers of the management software and bootloader.
Figure 92 is an example of the information.
Figure 92. SHOW BOOT Command
The fields are described in Figure 48.
Table 48. SHOW BOOT Command
Field Description
Current software The version number of the AlliedWare
Plus Management Software on the switch.
Current boot image The version number of the bootloader.
Default boot config The name of the boot configuration file
used by the switch to configure its
parameters after “NO BOOT CONFIG-
FILE” on page 455. This parameter
cannot be changed.
Current boot config The name of the active boot configuration
file on the switch.
Current software: v2.1.1
Current boot image: v2.1.1
Default boot config: /cfg/boot.cfg
Current boot config: /cfg/switch2.cfg (file exists)