Allied Telesis AT-9000 Series - Manual (Page 948)

Chapter 61: 802.1x Port-based Network Access Control Commands
920
NO AUTH REAUTHENTICATION
Syntax
no auth reauthentication
Parameters
None
Mode
Port Interface mode
Description
Use this command to remove reauthentication from authenticator ports so
that clients do not have to periodically reauthenticate after the initial
authentication. Reauthentication is still required if there is a change to the
status of the link between a client and the switch or the switch is reset or
power cycled.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 923
“SHOW DOT1X INTERFACE” on page 928
Example
This example deactivates reauthentication on port 2:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# no auth reauthentication