Allied Telesis AT-9000 Series - Manual (Page 260)

Chapter 12: Power Over Ethernet Commands
232
NO POWER-INLINE ENABLE
Syntax
no power-inline enable
Parameters
None
Mode
Port Interface mode
Description
Use this command to disable PoE on the ports. Ports do not transmit
power when PoE is disabled, but they do forward network traffic.
Confirmation Commands
“SHOW POWER-INLINE” on page 246
“SHOW POWER-INLINE INTERFACE” on page 251
“SHOW POWER-INLINE INTERFACE DETAIL” on page 252
Example
The following example disables PoE on ports 10, 11 and 12:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.10-port1.0.12
awplus(config-if)# no power-inline enable