Allied Telesis AT-9000 Series - Manual (Page 573)

545
Chapter 39
LACP Commands
The LACP port trunk commands are summarized in Table 59 and
described in detail within the chapter.
Table 59. LACP Port Trunk Commands
Command Mode Description
“CHANNEL-GROUP” on page 546 Port Interface Creates new aggregators and adds
ports to existing aggregators.
“LACP SYSTEM-PRIORITY” on
page 548 Global
Configuration Sets the LACP system priority value
for the switch.
“NO CHANNEL-GROUP” on
page 549 Port Interface Removes ports from aggregators and
deletes aggregators.
“PORT-CHANNEL LOAD-BALANCE”
on page 550 LACP Port
Trunk Interface Sets the load distribution method.
“SHOW ETHERCHANNEL” on
page 552 Privileged Exec Displays the ports of the aggregators
on the switch.
“SHOW ETHERCHANNEL DETAIL”
on page 553 Privileged Exec Displays the states of the ports of the
aggregators.
“SHOW ETHERCHANNEL
SUMMARY” on page 555 Privileged Exec Displays detailed information about
the aggregators.
“SHOW LACP SYS-ID” on page 556 Privileged Exec Displays the LACP priority value and
MAC address of the switch.
“SHOW PORT ETHERCHANNEL” on
page 557 Privileged Exec Displays the LACP port information.