Allied Telesis AT-9000 Series - Manual (Page 261)

AT-9000 Switch Command Line User’s Guide
233
NO POWER-INLINE MAX
Syntax
no power-inline max
Parameters
None
Mode
Port Interface mode
Description
Use this command to restore the default maximum power limits on the
ports. The default power limits are based on the power classes of the PDs.
See “Managing the Maximum Power Limit on Ports” on page 222 for
details.
Confirmation Commands
“SHOW POWER-INLINE” on page 246
“SHOW POWER-INLINE INTERFACE” on page 251
“SHOW POWER-INLINE INTERFACE DETAIL” on page 252
Example
This example restores the default maximum power limit on port 6:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# no power-inline max