Allied Telesis AT-9000 Series - Manual (Page 929)

AT-9000 Switch Command Line User’s Guide
901
AUTH TIMEOUT QUIET-PERIOD
Syntax
auth timeout quiet-period value
Parameters
quiet-period
Sets the number of seconds that an authenticator port remains in
the quiet state following a failed authentication exchange with a
client. The range is 1 to 65,535 seconds. The default value is 60
seconds.
Mode
Port Interface mode
Description
Use this command to set the number of seconds that an authenticator port
waits after a failed authentication with a client before accepting
authentication requests again.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 923 or “SHOW DOT1X
INTERFACE” on page 928
Example
This example sets the quiet period to 20 seconds on authenticator port 19:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.19
awplus(config-if)# auth timeout quiet-period 20