Allied Telesis AT-9000 Series - Manual (Page 55)

AT-9000 Switch Command Line User’s Guide
27
Note
A VLAN must be identified in this command by its VID and not by its
name.
VLAN
DATABASE
Command
You use this command to move from the Global Configuration mode to the
VLAN Configuration mode, which has the commands for creating VLANs.
The format of the command is:
vlan database
Figure 12. VLAN DATABASE Command
LOCATION
CIVIC-
LOCATION
Command
You use this command to move from the Global Configuration mode to the
Civic Location mode, to create LLDP civic location entries. The format of
the command is:
location civic-location id_number
This example assigns the ID number 16 to a new LLDP civic location
entry:
Figure 13. LLDP LOCATION CIVIC-LOCATION Command
LOCATION
COORD-
LOCATION
Command
You use this command to move from the Global Configuration mode to the
Coordinate Location mode, to create LLDP coordinate location entries.
The format of the command is:
location coord-location id_number
This example assigns the ID number 8 to a new LLDP coordinate location
entry:
Figure 14. LLDP LOCATION COORD-LOCATION Command
awplus(config)# vlan database
awplus(config-vlan)#
awplus(config)# location civic-location 16
awplus(config-civic)#
awplus(config)# location coord-location 8
awplus(config-coord)#