HP StorageWorks 2.32 SAN Switch - Manual (Page 274)

Switch View
4–118 Web Tools Version 3.0.x/4.0.x User Guide
Refresh Click to view the most current configuration information.
Log Area Displays coded messages:
• Successful changes to settings are logged in italics.
• Error messages are indicated in red.
• Warning messages are indicated in orange.
• Additional information is indicated in magenta.
QuickHelp Status
bar Displays one-line description about entry fields or tool tip on
any modifiable component. A green icon indicates that a
switch is enabled; a red icon is displayed when the switch is
disabled using the Admin tool.
Table 4–38: Configure Tab, System Services Sub-tab Fields
System Services Sub-tab
rstatd Select to dynamically enable or disable a server that returns
information about system operation information through
remote procedure calls.
rapid Check box to enable rapid system service.
rusersd Select to dynamically enable or disable a server that returns
information about the user who is logged into the system
through remote procedure calls.
Disable RLS
Probing Check box to disable Read Link Status probing of AL_PAs.
OK Select to save the changes made to the tab and to exit the
view.
Apply Select to save the changes made to this tab and to stay in
the current tab. Additional changes can be made and the
Apply button pressed when making changes incrementally.
Close Select to exit the current view.
Reset Select to reset the tab to the last set of committed changes.
If the Apply button has not been pressed on this tab, the
parameters are returned to the original values the tab had
when it was initially displayed.
Refresh Select to view the most current configuration information.
Table 4–37: Configure Tab, Arbitrated Loop Sub-tab Fields (Continued)