HP StorageWorks 2.32 SAN Switch - Manual (Page 272)

Switch View
4–116 Web Tools Version 3.0.x/4.0.x User Guide
Suppress Class F
Traffic Apply only if VC Encoded Address Mode is also set. When
set, translative addressing is disabled.
OK Select to save the changes made to the tab and to exit the
view.
Apply Click to save the changes made to this tab and to stay in the
current tab. Additional changes can be made and the Apply
button pressed when making changes incrementally.
Close Click to exit the current view.
Reset Click to reset the tab to the last set of committed changes. If
the Apply button has not been pressed on this tab, the
parameters are returned to the original values the tab had
when it was initially displayed.
Refresh Click to view the most current configuration information.
Log Area The log area is coded.
Successful changes to settings are logged in italics.
Error messages are indicated in red.
Warning messages are indicated in orange.
Additional information is indicated in magenta.
QuickHelp Status
bar Displays a one-line description about entry fields or a tool tip
on any modifiable component. A green icon indicates that a
switch enabled; a red icon is displayed when the switch is
disabled using the Admin tool.
Table 4–36: Configure Tab, Virtual Channel Sub-tab Fields
Virtual Channel Sub-tab
VC Priority
[number] Click to enable fine tuning for a specific application by
configuring the parameters for eight virtual channels.
OK Click to save the changes made to the tab and to exit the
view.
Apply Click to save the changes made to this tab and to stay in the
current tab. Additional changes can be made and the Apply
button pressed when making changes incrementally.
Close Click to exit the current view.
Table 4–35: Configure Tab, Fabric Sub-tab Fields (Continued)