HP StorageWorks 2.32 SAN Switch - Manual (Page 235)

Switch View
–79 Web Tools Version 3.0.x/4.0.x User Guide 4–79
Configure Tab
The Configure tab provides the same functionality as the command-line command
configure . The following actions are controllable from the Configure tab: Fabric
Parameters, Virtual Channel Parameters, Arbitrated Loop Parameters and Systems
Services. The valid values for each editable field are provided in the HP StorageWorks
Fabric OS Version 3.0.x/4.0.x Reference Guide description of the
configure
command. The Configure tab is shown in Figure 4–57.
QuickLoop Status section:
Enable Click the radio button to enable the switch for QuickLoop.
Disable Click the radio button to disable the switch for QuickLoop.
Port Displays the port numbers.
Enabled Check box to enable a port for QuickLoop, or uncheck to
disable the port for QuickLoop.
Local Switch Port Lists the ports connected to the local switch.
Local Switch
AL_PAs Lists the AL_PAs of devices connected to the local switch.
Partner Switch Port Lists the ports connected to a remote switch.
Partner Switch
AL_PAs Lists the AL_PAs of devices connected to a remote switch.
This information displays if a partner is configured.
OK Click to save the changes made to the tab and to exit the
tab.
Apply Click to save the changes made to this tab and to stay in
the current tab. Additional changes can be made and the
Apply button pressed when making changes incrementally.
Close Click to exit the current tab. If changes have been made
but not committed by clicking the Apply button, a dialog
box displays.
Reset Click to reset the tab to the last set of committed changes.
If the Apply button has not been pressed on this tab, the
parameters are returned to the original values the tab had
when it was initially displayed.
Table 4–22: QuickLoop Tab Fields (Continued)