HP StorageWorks 2.32 SAN Switch User Manual
Page 226
4–70
Web Tools Version 3.0.x/4.0.x User Guide
Bootswitch
Select the radio button to boot the switch.
Config Upload
Select the radio button to upload the configuration file to
the specified host. This allows for saving of the
configuration file to the switch using the specified filename
(full path). The User and Password must be valid for the
specified host, and the file path must be read-write
capable by the user.
Config Download
Select the radio button to download the firmware.
Config Default
Select the radio button to reset the configuration to the
default value.
Available in the Host Details section:
Protocol
Select the pull-down menu to chose the downloading
protocol.
User name
Enter the User Name.
Host IP
Enter the IP address of the host.
Filename
Enter the filename to be downloaded.
Available in the Boot Options section:
FastBoot
Select the radio button to do a Fastboot on the switch. This
will allow the switch to skip over the POST test.
Reboot
Select the radio button to reboot the switch.
Power on Self-Test
Check the box to have the switch do a POST test when it
reboots or uncheck the box to skip POST test for next
reboot.
Reboot After
Download
Check the box to have the switch reboot automatically
after the firmware download.
OK
Select and exit the tab to save any changes made.
Apply
Select to save any changes made to this tab and remain in
the tab. Additional changes can be made and the Apply
button pressed when making changes incrementally.
Close
Select to exit the Firmware/Configuration file tab. If
changes have been made and not committed, a dialog box
will display asking if you want to save the changes.
Reset
Select to reset the tab to the last set of saved changes.
Table 4–18: Firmware/Configuration File Administration Tab Fields (Continued)