HP StorageWorks 2.32 SAN Switch - Manual (Page 157)

4
Switch View
This chapter describes the views and interfaces available through Switch View, as
follows:
• Switch Events View on page 4–6
• Fabric Watch View V3.0.x (Optional Software) on page 4–8
• Fabric Watch View V4.0.x (Optional Software) on page 4–19
• Performance Monitor on page 4–26
• Administrative Interface V3.0.x on page 4–61
• Administrative Interface 4.0.x on Administrative Interface 4.0.x on page 4–93
• Telnet Interface on page 4–130
• High Availability on page 4–131
Switch View
Switch View represents the front panel of the switch, and displays when you click a
Switch icon in Fabric View. This view provides information about the overall status of
the switch and the status of the individual elements in the switch. The information
displayed is as close as possible to a real-time view of switch status. If the switch is
not functioning properly, a message explains the problem detected.
NOTE: Switch status is stored as the variable switchStatus, and is updated approximately once
every 15 seconds; however, the initial display does not occur until 30-60 seconds after the
switch is booted.
Accessing Switch View
1. Launch Web Tools, displaying Fabric View.
2. Click a Switch icon.
The Switch View displays, as shown in Figure 4–1 and Figure 4–2.