Modifying system parameter default values – Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide User Manual
Page 42

System parameters in show default values command (Continued)
TABLE 5
Parameter
Definition
ip-route
Learned IP routes
ip-static-arp
Static IP ARP entries
ip-static-route
Static IP routes
ip-subnet-port
IP subnets per port
l3-vlan
Layer 3 VLANs
mac
MAC entries
mac-filter-port
MAC address filter entries per port
mac-filter-sys
MAC address filter entries per system
multicast-route
Multicast routes
pim-mcache
PIM multicast cache entries
rmon-entries
RMON control table entries
session-limit
Session entries
spanning-tree
Spanning tree instances
view
SNMP views
virtual-interface
Virtual routing interfaces
vlan
VLANs
mld-max-group-addr
MLD group limit
igmp-snoop-mcache
IGMP snooping cache entries
mld-snoop-mcache
MLD snooping cache entries
Modifying system parameter default values
Information for the configurable tables appears under the columns that are shown in bold type in the
above examples. To simplify configuration, the command parameter you enter to configure the table is
used for the table name. For example, to increase the capacity of the IP route table, enter the following
commands.
device(config)#system-max ip-route 120000
device(config)#write memory
device(config)#exit
device#reload
Syntax: system-max ip-route num
Modifying system parameter default values
42
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide
53-1003086-04