Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 223)

NOTE
The actual interval is a random value between the Leaveall interval and 1.5 * the Leaveall time or the
maximum Leaveall time, whichever is lower.
NOTE
You can increase the maximum configurable value of the Leaveall timer from 300000 ms up to
1000000 ms using the gvrp-max-leaveall-timer command. (Refer to
Increasing the maximum
configurable value of the Leaveall timer on page 220.)
Timer configuration requirements
• All timer values must be in multiples of 100 ms.
• The Leave timer must be >= 3* the Join timer.
• The Leaveall timer must be >= 5* the Leave timer.
• The GVRP timers must be set to the same values on all the devices that are exchanging information
using GVRP.
Changing the Join, Leave, and Leaveall timers
The same CLI command controls changes to the Join, Leave, and Leaveall timers. To change values to
the timers, enter a command such as the following.
device(config-gvrp)#join-timer 1000 leave-timer 3000 leaveall-timer 15000
This command changes the Join timer to 1000 ms, the Leave timer to 3000 ms, and the Leaveall timer
to 15000.
Syntax: [no] join-timer ms leave-timer ms leaveall-timer ms
NOTE
When you enter this command, all the running GVRP timers are canceled and restarted using the new
times specified by the command.
Resetting the timers to their defaults
To reset the Join, Leave, and Leaveall timers to their default values, enter the following command.
device(config-gvrp)#default-timers
Syntax: default-timers
This command resets the timers to the following values:
• Join - 200 ms
• Leave - 600 ms
• Leaveall - 10000 ms
Timer configuration requirements
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide 223
53-1003086-04