Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 196)

FIGURE 34 Single level MCT configuration
Client 1 - Configuration
If client 1 is a Brocade switch in Figure 34 on page 196, you can configure it as follows:
!
vlan 1905 by port
tagged ethe 7/1/1 to 7/1/3 ethe 8/1/1 to 8/1/3
spanning-tree
!
!
lag lag_client1_1 dynamic id 100
ports ethe 7/1/1 to 7/1/3 ethe 8/1/1 to 8/1/3
primary-port 7/1/1
deploy
!
Client 2- Configuration
If client 2 is a Brocade switch in Figure 34 on page 196, you can configure it as follows:
!
vlan 1905 by port
tagged ethe 1/1/1 to 1/1/3 ethe 3/1/1 to 3/1/3
spanning-tree
!
lag lag_client2_1 dynamic id 200
Client 1 - Configuration
196 FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide
53-1003086-04