Displaying information about ethernet interfaces – Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide User Manual

Page 192

Rbridge ID of the peer 100

Session state of the peer OPERATIONAL

Next message ID to be send 287

Keep Alive interval in seconds 30

Hold Time Out in seconds 90

Fast Failover is enable for the session

UP Time 0 days: 2 hr:22 min:58 sec

Number of tcp packet allocations failed 0

Message Init Keepalive Notify Application Badmessages

Send 3 2421 2 53 0

Receive 3 2415 0 37 0

TCP connection is up

TCP connection is initiated by 10.1.1.2

TCP connection tcbHandle not pending

TCP connection packets not received

**************TCP Connection Details*********************

TCP Connection state: ESTABLISHED Maximum segment size: 1436

Local host: 10.1.1.2, Local Port: 12203

Remote host: 10.1.1.1, Remote Port: 4175

ISentSeq: 1867652277 SendNext: 1867660731 TotUnAck: 0

TotSent: 8454 ReTrans: 9 UnAckSeq: 1867660731

IRcvSeq: 3439073167 RcvNext: 3439078415 SendWnd: 16384

TotalRcv: 5248 DupliRcv: 16 RcvWnd: 16384

SendQue: 0 RcvQue: 0 CngstWnd: 1452

Syntax: show cluster [ cluster_name/cluster-id ] ccp peer [ details ]

Displaying information about Ethernet interfaces

Use the show interface ethernet command to display information about Ethernet interfaces. The
MCT-related information is shown in bold in the following example.

device# show interface ethernet 7/1

...

GigabitEthernet7/1 is disabled, line protocol is down

Hardware is GigabitEthernet, address is 0024.3822.8260 (bia 0024.3822.8260)

Configured speed auto, actual unknown, configured duplex fdx, actual unknown

Configured mdi mode AUTO, actual unknown

Member of L2 VLAN ID 1, port is untagged, port state is DISABLED

BPDU guard is Disabled, ROOT protect is Disabled

Link Error Dampening is Disabled

STP configured to ON, priority is level0

Flow Control is config enabled, oper disabled, negotiation disabled

Mirror disabled, Monitor disabled

Not member of any active trunks

Not member of any configured trunks

No port name

IPG MII 96 bits-time, IPG GMII 96 bits-time

MTU 1500 bytes, encapsulation Ethernet

ICL port for icl1 in cluster id 1

300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization

300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization

0 packets input, 0 bytes, 0 no buffer

Received 0 broadcasts, 0 multicasts, 0 unicasts

0 input errors, 0 CRC, 0 frame, 0 ignored

0 runts, 0 giants

0 packets output, 0 bytes, 0 underruns

Transmitted 0 broadcasts, 0 multicasts, 0 unicasts

0 output errors, 0 collisions

Relay Agent Information option: Disabled

show interface ethernet 7/3

GigabitEthernet7/3 is disabled, line protocol is down

Hardware is GigabitEthernet, address is 0024.3822.8262 (bia 0024.3822.8262)