Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 351)

Configuring port-based VLANs on FSX-B
Enter the following commands to configure FSX-B.
device> en
device# configure terminal
device(config)# hostname FSX-B
device-B(config)# vlan 2 name BROWN
device-B(config-vlan-2)# untagged ethernet 1 to 4
device-B(config-vlan-2)# tagged ethernet 25 to 26
device-B(config-vlan-2)# spanning-tree
device-B(config-vlan-2)# spanning-tree priority 500
device-B(config-vlan-2)# vlan 3 name GREEN
device-B(config-vlan-3)# untagged ethernet 5 to 8
device-B(config-vlan-3)# tagged ethernet 25 to 26
device-B(config-vlan-3)# spanning-tree
device-B(config-vlan-3)# spanning-tree priority 500
device-B(config-vlan-3)# vlan 4 name BLUE
device-B(config-vlan-4)# untagged ethernet 9 to 12
device-B(config-vlan-4)# tagged ethernet 25 to 26
device-B(config-vlan-4)# vlan 5 name RED
device-B(config-vlan-5)# untagged ethernet 13 to 16
device-B(config-vlan-5)# tagged ethernet 25 to 26
device-B(config-vlan-5)# end
device-B# write memory
Configuring port-based VLANs on FSX-C
Enter the following commands to configure FSX-C.
device> en
device# configure terminal
device(config)# hostname FSX-C
device-C(config)# vlan 2 name BROWN
device-C(config-vlan-2)# untagged ethernet 1 to 4
device-C(config-vlan-2)# tagged ethernet 25 to 26
device-C(config-vlan-2)# vlan 3 name GREEN
device-C(config-vlan-3)# untagged ethernet 5 to 8
device-C(config-vlan-3)# tagged ethernet 25 to 26
device-C(config-vlan-3)# vlan 4 name BLUE
device-C(config-vlan-4)# untagged ethernet 9 to 12
device-C(config-vlan-4)# tagged ethernet 25 to 26
device-C(config-vlan-4)# vlan 5 name RED
device-C(config-vlan-5)# untagged ethernet 13 to 16
device-C(config-vlan-5)# tagged ethernet 25 to 26
device-C(config-vlan-5)# end
device-C# write memory
Syntax: vlan vlan-id by port
Syntax: untagged ethernet [slotnum/]portnum [to [slotnum/]portnum | ethernet [slotnum/]portnum]
Syntax: tagged ethernet [slotnum/]portnum [to <[slotnum/]portnum> | ethernet [slotnum/]portnum]
Syntax: [no] spanning-tree
Syntax: spanning-tree [ ethernet [slotnum/]portnum path-cost value priority value] forward-delay
value hello-time value maximum-age time priority value
Modifying a port-based VLAN
You can make the following modifications to a port-based VLAN:
• Add or delete a VLAN port.
• Enable or disable STP.
Configuring port-based VLANs on FSX-B
FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide 351
53-1003086-04