Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 184)

Layer 3 Feature Support with MCT (Continued) TABLE 32
Feature Sub-feature Session VLAN VE Member
VLAN VE
Design Philosophy
proxy-arp No Yes
redirect No Yes
rip No No
tcp Yes Yes
tunnel No No
use-acl-on-arp Yes Yes
vrrp No Yes
vrrp-extended No Yes
ipv6 No No • IPv6 is not supported for MCT
management
• IPv6 not supported on member
VLAN VE
a.) *ICL: The ICL port is added as default whenever a CCEP is in OIF. The data traffic received from the ICL port is filtered out by a
dynamically programmed egress filter on the CCEPs.
Layer 3 unicast over MCT
This section provides sample configurations for the Layer 3 unicast configuration depicted in the
following figure.
Layer 3 unicast over MCT
184 FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide
53-1003086-04