Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide - Manual (Page 356)

vlan 21 by port
tagged ethe 1/1/1
spanning-tree 802-1w
!
vlan 22 by port
tagged ethe 1/1/1
spanning-tree 802-1w
!
vlan 23 by port
tagged ethe 1/1/1
spanning-tree 802-1w
!
vlan 24 by port
tagged ethe 1/1/1
spanning-tree 802-1w
!
!
output omitted
!
!
Now you can modify any one or some of the VLANs. See the example below.
In the following example, disable the spanning tree 802.1w on VLANs 22,23 and 24, And, verify with
show running-config output that the spanning tree 802.1w is disabled on specified VLANs, VLAN 22,
23 and 24 and not on the VLANs 16, 17, 20 and 21.
device(config)#vlan 22 to 24
device(config-mvlan-22-24)#no span 8
device(config-mvlan-22-24)#exit
device(config)#show run
Current configuration:
output omitted
!
!
vlan 1 name DEFAULT-VLAN by port
!
vlan 16 by port
tagged ethe 1/1/1
spanning-tree 802-1w
!
vlan 17 by port
tagged ethe 1/1/1
spanning-tree 802-1w
!
vlan 20 by port
tagged ethe 1/1/1
spanning-tree 802-1w
!
vlan 21 by port
tagged ethe 1/1/1
spanning-tree 802-1w
vlan 22 by port
tagged ethe 1/1/1
!
vlan 23 by port
tagged ethe 1/1/1
!
vlan 24 by port
tagged ethe 1/1/1
output omitted
Multi-range VLAN show commands
This section describes the show commands for multi-range VLAN parameters.
In the multi-range VLAN mode, some of the Show commands are also available. The output of the
Show commands in multi-range VLAN mode displays the information related to the specific VLANs
only. See the example below.
VLANs
356 FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide
53-1003086-04