beautypg.com

Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide User Manual

Page 152

background image

Show LAG information (Continued)

TABLE 29

This field...

Displays...

Link

The status of the link which can be one of the following:

• up
• down

State

The L2 state for the port.

Dupl

The duplex state of the port, which can be one of the following:

• Full
• Half
• None

Speed

The bandwidth of the interface.

Trunk

The LAG ID of the port.

Tag

Indicates whether the ports have 802.1q VLAN tagging. The value can be Yes or No.

Pri

Indicates the Quality of Service (QoS) priority of the ports. The priority can be a value
from 0-7.

MAC

The MAC address of the port.

Name

The name (if any) configured for the port.

Sys P

Lists the system priority configured for the device.

Port P

Lists the port’s link aggregation priority.

Key

Lists the link aggregation key.

Act

Indicates the link aggregation mode, which can be one of the following:

• No - The mode is passive on the port.

If link aggregation is enabled (and the mode is passive), the port can send and receive
LACPDU messages to participate in negotiation of an aggregate link initiated by
another port, but cannot search for a link aggregation port or initiate negotiation of an
aggregate link.

• Yes - The mode is active. The port can send and receive LACPDU messages.

Tio

Indicates the timeout value of the port. The timeout value can be one of the following:

• L - Long. The LAG group has already been formed and the port is therefore using a

longer message timeout for the LACPDU messages exchanged with the remote port.
Typically, these messages are used as confirmation of the health of the aggregate link.

• S - Short. The port has just started the LACPDU message exchange process with the

port at the other end of the link. The S timeout value also can mean that the link
aggregation information received from the remote port has expired and the ports are
starting a new information exchange.

Link Aggregation

152

FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide

53-1003086-04