beautypg.com

Fixed core and fixed edge – Brocade FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide User Manual

Page 233

background image

device(config-gvrp)#enable ethernet 1/24 ethernet 6/24 ethernet 8/17

device(config-gvrp)#block-learning ethernet 1/24 ethernet 6/24 ethernet 8/17

These VLAN commands configure VLANs 20, 30, 40, and 50. The GVRP commands enable the
protocol on the ports that are connected to the edge devices, and disable VLAN learning on those ports.
All the VLANs are advertised by GVRP.

Enter the following commands on edge devices A, B, and C.

device> enable

device#configure terminal

device(config)#gvrp-enable

device(config-gvrp)#enable all

device(config-gvrp)#block-applicant all

Fixed core and fixed edge

The VLANs are statically configured on the core and edge devices. On each edge device, VLAN
advertising is enabled but learning is disabled. GVRP is not configured on the core device. This
configuration enables the devices in the edge clouds to learn the VLANs configured on the edge
devices.

This configuration does not use any GVRP configuration on the core device.

The configuration on the edge device is the same as in

Dynamic core and fixed edge

on page 231.

Fixed core and fixed edge

FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide

233

53-1003086-04