PLANET WGS3-24240 - Manual (Page 95)

User’s Manual of WGS3-24000 / WGS3-24240
95
4.2.11 DHCP Server
The Dynamic Host Configuration Protocol (DHCP) Server gives out IP addresses when a device is booting up and request an IP
to logged on to the network. It must be set as a DHCP client to obtain the IP address sutomatically.
4.2.11.1 Global Configuration
Figure 4-2-50 DHCP Server Global Configuration
Configurable Data
Object Description
• Admin Mode Specifies if the DHCP Service is to be Enabled or Disabled.
Default value is Disable.
• Ping Packet Count Specifies the number of packets a server sends to a Pool address to check for
duplication as part of a ping operation.
Default value is 2. Valid Range is (0, 2 to 10).
Setting the value to 0 will disable the function.
• Conflict Logging Mode Specifies if conflict logging on a DHCP Server is to be Enabled or Disabled.
Default value is Enable.
• Bootp Automatic Mode Specifies if Bootp for dynamic pools is to be Enabled or Disabled.
Default value is Disable.
• Add Excluded
Addresses
Specifies the IP addresses that the server should not assign to the client.
• From - Specifies the low address in case the user wants to exclude a range of
addresses. Specifies the address to be Excluded in case the user wants to
exclude a single address.