PLANET WGS3-24240 - Manual (Page 228)

User’s Manual of WGS3-24000 / WGS3-24240
228
Configurable Data
Object Description
• Interface Trust Mode
Specifies whether or not to trust a particular packet marking at ingress.
Interface Trust Mode can only be one of the following:
• untrusted
• trust dot1p
• trust ip-precedence
• trust ip-dscp
Default value is trust dot1p.
• IP Precedence Traffic
Class
Specify which internal traffic class to map the corresponding IP Precedence
value. Valid Range is (0 to 7) .
• IP DSCP Traffic Class Specify which internal traffic class to map the corresponding IP DSCP value.
Valid Range is (0 to 7) .
Non-Configurable Data
Object Description
• Untrusted Traffic Class Displays traffic class (i.e. queue) to which all traffic is directed when in 'untrusted'
mode.
Valid Range is (0 to 7).
• Non-IP Traffic Class Displays traffic class (i.e. queue) to which all non-IP traffic is directed when in
'trust ip-precedence' or 'trust ip-dscp' mode.
Valid Range is (0 to 7).
• 802.1p Priority Displays the 802.1p priority to be mapped.
• IP Precedence Value Displays IP Precedence value.
Valid Range is (0 to 7).
• IP DSCP Value Displays IP DSCP value. Valid Range is (0 to 63).
• Submit button Send the updated configuration to the switch. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a
save is performed.
• Restore Defaults
button
Restores default settings.