PLANET WGS3-24240 - Manual (Page 493)

User’s Manual of WGS3-24000 / WGS3-24240
493
12.6.2 bootpdhcprelay enable
This command enables the forwarding of relay requests for BootP/DHCP Relay on the system.
▫ Default disabled
▫ Format bootpdhcprelay enable
▫ Mode Global Config
12.6.2.1 no bootpdhcprelay enable
This command disables the forwarding of relay requests for BootP/DHCP Relay on the system.
▫ Format no bootpdhcprelay enable
▫ Mode Global Config
12.6.3 bootpdhcprelay maxhopcount
This command configures the maximum allowable relay agent hops for BootP/DHCP Relay on the system. The
parameter has a range of 1 to 16.
▫ Default 4
▫ Format bootpdhcprelay maxhopcount <1-16>
▫ Mode Global Config
12.6.3.1 no bootpdhcprelay maxhopcount
This command configures the default maximum allowable relay agent hops for BootP/DHCP Relay on the system.
▫ Format no bootpdhcprelay maxhopcount
▫ Mode Global Config
12.6.4 bootpdhcprelay minwaittime
This command configures the minimum wait time in seconds for BootP/DHCP Relay on the system. When the BOOTP relay
agent receives a BOOTREQUEST message, it MAY use the seconds-since-client-began-booting field of the request as a factor
in deciding whether to relay the request or not. The parameter has a range of 0 to 100 seconds.
▫ Default 0
▫ Format bootpdhcprelay minwaittime <0-100>
▫ Mode Global Config
12.6.4.1 no bootpdhcprelay minwaittime
This command configures the default minimum wait time in seconds for BootP/DHCP Relay on the system.
▫ Format no bootpdhcprelay minwaittime
▫ Mode Global Config