PLANET WGS3-24240 User Manual
Page 205
User’s Manual of WGS3-24000 / WGS3-24240
205
Selection Criteria
Object
Description
• IP ACL ID
Use the pulldown menu to select the IP ACL for which to create or update a rule
• Rule
Select an existing rule from the pulldown menu, or select 'Create New Rule.' ACL
as well as an option to add a new Rule. New rules cannot be created if the
maximum number of rules has been reached. For each rule, a packet must
match all the specified criteria in order to be true against that rule and for the
specified rule action (Permit / Deny) to take place.
Configurable Data
Object
Description
• Rule ID -
Enter a whole number in the range of 1 to 9 that will be used to identify the rule.
An IP ACL may have up to 9 rules.
• Action -
Specify what action should be taken if a packet matches the rule's criteria. The
choices are permit or deny.
• Assign Queue ID -
Specifies the hardware egress queue identifier used to handle all packets
matching this IP ACL rule. Valid range of Queue Ids is (0 to 7).
This field is visible when 'Permit' is chosen as 'Action'.
• Redirect Interface -
Specifies the specific egress interface where the matching traffic stream is
forced, bypassing any forwarding decision normally performed by the device.
This field is visible when 'Permit' is chosen as 'Action'.
• Match Every -
Select true or false from the pulldown menu. True signifies that all packets will
match the selected IP ACL and Rule and will be either permitted or denied. In this
case, since all packets match the rule, the option of configuring other match
criteria will not be offered.
To configure specific match criteria for the rule, remove the rule and re-create it,
or re-configure 'Match Every' to 'False' for the other match criteria to be visible.
• Protocol Keyword -
Specify that a packet's IP protocol is a match condition for the selected IP ACL
rule. The possible values are ICMP, IGMP, IP, TCP, and UDP. Either the
'Protocol Keyword' field or the 'Protocol Number' field can be used to specify an
IP protocol value as a match criterion.
• Protocol Number -
Specify that a packet's IP protocol is a match condition for the selected IP ACL
rule and identify the protocol by number. The protocol number is a standard value