PLANET WGS3-24240 - Manual (Page 507)

User’s Manual of WGS3-24000 / WGS3-24240
507
12.7.37 redistribute (OSPF)
This command configures OSPF protocol to allow redistribution of routes from the specified source protocol/routers.
▫ Default metric—unspecified
type—2
tag—0
▫ Format redistribute {rip | bgp | static | connected} [metric <016777214>] [metric-type {1 | 2}] [tag
<0-4294967295>] [subnets]
▫ Mode Router OSPF Config
no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the specified source protocol/routers.
▫ Format no redistribute {rip | bgp | static | connected} [metric] [metric-type] [tag] [subnets]
▫ Mode Router OSPF Config
12.7.38 maximum-paths (OSPF)
This command sets the number of paths that OSPF can report for a given destination where maxpaths is platform dependent.
▫ Default 4
▫ Format maximum-paths
▫ Mode Router OSPF Config
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back to its default value.
▫ Format no maximum-paths
▫ Mode Router OSPF Config
12.7.39 timers spf
Use this command to configure the SPF delay time and hold time. The valid range for both parameters is 0-65535 seconds.
▫ Default delay-time—5
hold-time—10
▫ Format timers spf
▫ Mode Router OSPF Config
12.7.40 trapflags (OSPF)
This command enables OSPF traps.
▫ Default enabled
▫ Format trapflags