PLANET WGS3-24240 - Manual (Page 238)

User’s Manual of WGS3-24000 / WGS3-24240
238
4.6.1 IP
4.6.1.1 IP Configuration
Use this menu to configure routing parameters for the switch as opposed to an interface.
Figure 4-6-1 IP Configuation
Configurable Data
Object Description
• Routing Mode Select enable or disable from the pulldown menu. You must enable routing for
the switch before you can route through any of the interfaces. The default value
is disable.
• IP Forwarding Mode Select enable or disable from the pulldown menu. This enables or disables the
forwarding of IP frames. The default value is enable.
Non-Configurable Data
Object Description
• Default Time to Live The default value inserted into the Time-To-Live field of the IP header of
datagrams originated by the switch, if a TTL value is not supplied by the transport
layer protocol.
• Maximum Next Hops The maximum number of hops supported by the switch. This is a compile-time
constant.