PLANET WGS3-24240 User Manual
Page 287
User’s Manual of WGS3-24000 / WGS3-24240
287
4.6.5.3 Route Entry Configuration
Figure 4-6-33 Route Route Entry Configuration
Selection Criteria
Object
Description
• Network Address
Specifies the IP route prefix for the destination. In order to create a route a valid
routing interface must exist and the next hop IP Address must be on the same
network as the routing interface. Routing interfaces are created on the IP
Interface Configuration page. Valid next hop IP Addresses can be viewed on the
'Route Table' screen.
• Route Type
This field can be either default or static. If creating a default route, all that needs
to be specified is the next hop IP address, otherwise each field needs to be
specified.
Configurable Data
Non-Configurable Data
。
Subnet Mask - Also referred to as the subnet/network mask, this indicates the portion of the IP interface address that
identifies the attached network.
。
Protocol - This field tells which protocol created the specified route. The possibilities are one of the following:
Local
Static
Default
OSPF Intra
OSPF Inter
OSPF Type-1
OSPF Type-2
RIP
BGP4