PLANET WGS3-24240 - Manual (Page 488)

User’s Manual of WGS3-24000 / WGS3-24240
488
▫ Format no ip vrrp
Mode Global Config
12.5.2 ip vrrp (Interface Config)
Use this command in Interface Config mode to create a virtual router associated with the interface. The parameter is the
virtual router ID, which has an integer value range from 1 to 255.
▫ Format ip vrrp
▫ Mode Interface Config
12.5.2.1 no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with the interface. The virtual Router ID,
, is an integer value that ranges from 1 to 255.
▫ Format no ip vrrp
▫ Mode Interface Config
12.5.3 ip vrrp mode
This command enables the virtual router configured on the specified interface. Enabling the status field starts a virtual router.
The parameter is the virtual router ID which has an integer value ranging from 1 to 255.
▫ Default disabled
▫ Format ip vrrp mode
▫ Mode Interface Config
12.5.3.1 no ip vrrp mode
This command disables the virtual router configured on the specified interface. Disabling the status field stops a virtual router.
▫ Format no ip vrrp mode
▫ Mode Interface Config
12.5.4 ip vrrp ip
This command sets the virtual router IP address value for an interface. The value for is the IP address which is to be
configured on that interface for VRRP. The parameter is the virtual router ID which has an integer value range from 1 to
255. You can use the optional [secondary] parameter to designate the IP address as a secondary IP address.
▫ Default none
▫ Format ip vrrp ip [secondary]
▫ Mode Interface Config
12.5.4.1 no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value from the interface. To delete the primary IP