PLANET WGS3-24240 User Manual
Page 254
User’s Manual of WGS3-24000 / WGS3-24240
254
• Create
• Static
• Connected
• OSPF
• BGP
• Available Source -
This select box is a dynamic selector and would be populated by only those
Source Routes that have not previously been configured for redistribution by RIP.
This select box would appear only if the user selects "Create" option as
Configured Source. The valid values are
• Static
• Connected
• OSPF
• BGP
• Metric-
Sets the metric value to be used as the metric of redistributed routes. This field
displays the metric if the source was pre-configured and can be modified.
The valid values are (1 to 15)
• Match -
One or more of these checkboxes must be selected to set the type of OSPF
routes to be redistributed. This field would appear only if Source is "OSPF". This
field displays the configured match options if "OSPF" was pre-configured and can
be modified.
Internal - Sets Internal OSPF Routes to be redistributed
External 1 - Sets External Type 1 OSPF Routes to be redistributed
External 2 - Sets External Type 2 OSPF Routes to be redistributed
NSSA-External 1 - Sets NSSA External Type 1 OSPF Routes to be
redistributed
NSSA-External 2 - Sets NSSA External Type 2 OSPF Routes to be
redistributed
The default is Internal.
• Distribute List -
Sets the Access List that filters the routes to be redistributed by the destination
protocol. Only permitted routes are redistributed. If this command refers to a
non-existent access list, all routes are permitted. The valid values for Access List
IDs are (1 to 199). When used for route filtering, the only fields in an access list
that get used are
Source IP Address and netmask
Destination IP Address and netmask
Action (permit or deny)
All other fields (source and destination port, precedence, tos, etc.) are ignored.