PLANET WGS3-24240 - Manual (Page 259)

User’s Manual of WGS3-24000 / WGS3-24240
259
defined in Section 16.4.1 of the OSPF-2 standard (RFC 2328), which will prevent routing loops when
AS-external-LSAs for the same destination have been originated from different areas. The default value is 'enable'.
To prevent routing loops, you should select 'disable', but only if all OSPF routers in the routing domain are capable
of operating according to RFC 2328.
。 Exit Overflow Interval - Enter the number of seconds that, after entering overflow state, the router should wait
before attempting to leave overflow state. This allows the router to again originate non-default AS-external-LSAs. If
you enter 0, the router will not leave Overflow State until restarted. The range is 0 to 2147483647 seconds.
。 Default Metric - Sets a default for the metric of redistributed routes.This field displays the default metric if one has
already been set or blank if not configured earlier. The valid values are (1 to 16777215)
Default Route Advertise
Figure 4-6-16 OSPF Configuration
Object Description
• Default Information
Originate
Enable or Disable Default Route Advertise.
• Always Sets the router advertise 0.0.0.0/0.0.0.0 when set to "True".
• Metric Specifies the metric of the default route. The valid values are (0 to 16777215)
• Metric Type Sets the metric type of the default route.
Non-Configurable Data
Object Description
• ASBR Mode Reflects whether the ASBR mode is enabled or disabled. Enable implies that the
router is an autonomous system border router. Router automatically becomes an
ASBR when it is configured to redistribute routes learnt from other protocol.
• ABR Status The values of this are enabled or disabled. Enabled implies that the router is an
area border router. Disabled implies that it is not an area border router.