PLANET WGS3-24240 - Manual (Page 523)

User’s Manual of WGS3-24000 / WGS3-24240
523
no distance rip
This command sets the default route preference value of RIP in the router.
▫ Format no distance rip
▫ Mode Router RIP Config
12.8.8 distribute-list out (RIP)
This command is used to specify the access list to filter routes received from the source protocol. Default 0
▫ Format distribute-list <1-199> out {ospf | bgp | static | connected}
▫ Mode Router RIP Config
no distribute-list out
This command is used to specify the access list to filter routes received from the source protocol.
▫ Format no distribute-list <1-199> out {ospf | bgp | static | connected}
▫ Mode Router RIP Config
12.8.9 ip rip authentication
This command sets the RIP Version 2 Authentication Type and Key for the specified interface. The value of is either
none, simple, or encrypt. The value for authentication key [key] must be 16 bytes or less. The [key] is composed of standard
displayable, non-control keystrokes from a Standard 101/102-key keyboard. If the value of is encrypt, a keyid in the
range of 0 and 255 must be specified. Unauthenticated interfaces do not need an authentication key or authentication key ID.
▫ Default none
▫ Format ip rip authentication {none | {simple } | {encrypt }}
▫ Mode Interface Config
no ip rip authentication
This command sets the default RIP Version 2 Authentication Type for an interface.
▫ Format no ip rip authentication
▫ Mode Interface Config
12.8.10 ip rip receive version
This command configures the interface to allow RIP control packets of the specified version(s) to be received.
The value for is one of: rip1 to receive only RIP version 1 formatted packets, rip2 for RIP version 2, both to receive
packets from either format, or none to not allow any RIP control packets to be received.
▫ Default both
▫ Format ip rip receive version {rip1 | rip2 | both | none}
▫ Mode Interface Config