PLANET WGS3-24240 User Manual
Page 273
User’s Manual of WGS3-24000 / WGS3-24240
273
4.6.4.7 OSPF Neighbor Table
This screen displays the OSPF neighbor table list. When a particular neighbor ID is specified, detailed information about a
neighbor is given. The information below will only be displayed if OSPF is enabled.
Figure 4-6-24 OSPF Neighbor Table
Selection Criteria
Object
Description
• Slot/Port
Selects the interface for which data is to be displayed or configured. Slot 0 is the
base unit.
• Refresh button
Refresh the data on the screen with the present state of the data in the switch.
Non-Configurable Data
Object
Description
• Router ID
A 32 bit integer in dotted decimal format representing the neighbor interface.
• IP Address
The IP address of the neighboring router's interface to the attached network. It is
used as the destination IP address when protocol packets are sent as unicasts
along this adjacency. Also used in router-LSAs as the Link ID for the attached
network if the neighboring router is selected to be designated router. The
Neighbor IP address is learned when Hello packets are received from the
neighbor. For virtual links, the Neighbor IP address is learned during the routing
table build process.
• Neighbor Interface
Index
A Slot/Port identifying the neighbor interface index.