PLANET WGS3-24240 - Manual (Page 506)

User’s Manual of WGS3-24000 / WGS3-24240
506
This command sets the default OSPF retransmit Interval for the specified interface.
▫ Format no ip ospf retransmit-interval
▫ Mode Interface Config
12.7.34 ip ospf transmit-delay
This command sets the OSPF Transit Delay for the specified interface. The transmit delay is specified in seconds. In addition, it
sets the estimated number of seconds it takes to transmit a link state update packet over this interface. Valid values for
range from 1 to 3600 (1 hour).
▫ Default 1
▫ Format ip ospf transmit-delay <1-3600>
▫ Mode Interface Config
no ip ospf transmit-delay
This command sets the default OSPF Transit Delay for the specified interface.
▫ Format no ip ospf transmit-delay
▫ Mode Interface Config
12.7.35 ip ospf mtu-ignore
This command disables OSPF maximum transmission unit (MTU) mismatch detection. OSPF Database Description packets
specify the size of the largest IP packet that can be sent without fragmentation on the interface. When a router receives a
Database Description packet, it examines the MTU advertised by the neighbor. By default, if the MTU is larger than the router
can accept, the Database Description packet is rejected and the OSPF adjacency is not established.
▫ Default enabled
▫ Format ip ospf mtu-ignore
▫ Mode Interface Config
no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
▫ Format no ip ospf mtu-ignore
▫ Mode Interface Config
12.7.36 router-id (OSPF)
This command sets a 4-digit dotted-decimal number uniquely identifying the router ospf id. The is a configured
value.
▫ Format router-id
▫ Mode Router OSPF Config