PLANET WGS3-24240 - Manual (Page 211)

User’s Manual of WGS3-24000 / WGS3-24240
211
choices are permit or deny.
• Assign Queue ID Specifies the hardware egress queue identifier used to handle all packets
matching this ACL rule.
Valid range of Queue Ids is (0 to 7).
• Redirect Interface Specifies the specific egress interface where the matching traffic stream is
forced, bypassing any forwarding decision normally performed by the device.
• CoS Specifies the 802.1p user priority to compare against an Ethernet frame.
Valid range of values is (0 to 7).
• Destination MAC Specifies the destination MAC address to compare against an Ethernet frame.
Valid format is (xx:xx:xx:xx:xx:xx). The BPDU keyword may be specified using
a Destination MAC address of 01:80:C2:xx:xx:xx.
• Ethertype Key
Specifies the Ethertype value to compare against an Ethernet frame.
Valid values are
„ Appletalk
„ ARP
„ IBM SNA
„ IPv4
„ IPv6
„ IPX
„ MPLS multicast
„ MPLS unicast
„ NetBIOS
„ Novell
„ PPPoE
„ Reverse ARP
„ User Value
• Ethertype User Value Specifies the user defined customised Ethertype value to be used when the user
has selected "User Value" as Ethertype Key, to compare against an Ethernet
frame.
Valid range of values is (0x0600 to 0xFFFF).
• Source MAC Specifies the Source MAC address to compare against an Ethernet frame. Valid
format is (xx:xx:xx:xx:xx:xx).
• VLAN Specifies the VLAN ID to compare against an Ethernet frame. Valid range of
values is (0 to 4095). Either VLAN Range or VLAN can be configured.
• Match Every
Specifies an indication to match every Layer 2 MAC packet. Valid values are
• True - Signifies that every packet is considered to match the selected ACL
Rule.
• False - Signifies that it is not mandatory for every packet to match the
selected ACL Rule.