PLANET WGS3-24240 User Manual
Page 261
User’s Manual of WGS3-24000 / WGS3-24240
261
Figure 4-6-17 OSPF Interface Configuration
Selection Criteria
Object
Description
• Slot/Port
Select the interface for which data is to be displayed or configured.
Configurable Data
Object
Description
• OSPF Admin Mode*
You may select enable or disable from the pulldown menu. The default value is
'disable.' You can configure OSPF parameters without enabling OSPF Admin
Mode, but they will have no effect until you enable Admin Mode. The following
information will be displayed only if the Admin Mode is enabled: State,
Designated Router, Backup Designated Router, Number of Link Events, LSA Ack
Interval, and Metric Cost. For OSPF to be fully functional, you must enter a valid
IP Address and Subnet Mask via the Interface IP Configuration page or through