PLANET WGS3-24240 User Manual
Page 243
User’s Manual of WGS3-24000 / WGS3-24240
243
• Encapsulation Type
Select the link layer encapsulation type for packets transmitted from the specified
interface from the pulldown menu. The possible values are Ethernet and SNAP.
The default is Ethernet.
• Proxy Arp
Select to disable or enable proxy Arp for the specified interface from the pulldown
menu.
• IP MTU
Specifies the maximum transmission unit (MTU) size of IP packets sent on an
interface. Valid range is (68 to 1500).
Default value is 1500.
• Submit button
Update the switch with the values on this screen. If you want the switch to retain
the new values across a power cycle, you must perform a save.
• Delete IP Address
button
Delete the IP Address from the interface. Note that the address can not be
deleted if there are secondary addresses configured.
• Secondary IP Address
button
Proceed to the Secondary IP Address configuration screen.
Non-Configurable Data
Object
Description
• Administrative Mode
The Administrative Mode of the interface.
The default value is enable.
• Active State
The state of the specified interface is either Active or Inactive. An interface is
considered active if it the link is up and it is in forwarding state.
• MAC Address
The burned-in physical address of the specified interface. The format is six
two-digit hexadecimal numbers separated by colons, for example
00:06:29:32:81:40.