PLANET WGS3-24240 - Manual (Page 500)

User’s Manual of WGS3-24000 / WGS3-24240
500
no area virtual-link authentication
This command configures the default authentication type for the OSPF virtual interface identified by and .
The parameter is the Router ID of the neighbor.
▫ Format no area virtual-link authentication
▫ Mode Router OSPF Config
12.7.17 area virtual-link dead-interval (OSPF)
This command configures the dead interval for the OSPF virtual interface on the virtual interface identified by and
. The parameter is the Router ID of the neighbor. The range for seconds is 1 to 65535.
▫ Default 40
▫ Format area virtual-link dead-interval
▫ Mode Router OSPF Config
no area virtual-link dead-interval
This command configures the default dead interval for the OSPF virtual interface on the virtual interface identified by
and . The parameter is the Router ID of the neighbor.
▫ Format no area virtual-link dead-interval
▫ Mode Router OSPF Config
12.7.18 area virtual-link hello-interval (OSPF)
This command configures the hello interval for the OSPF virtual interface on the virtual interface identified by and
. The parameter is the Router ID of the neighbor. The range for is 1 to 65535.
▫ Default 10
▫ Format area virtual-link hello-interval <1-65535>
▫ Mode Router OSPF Config
no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on the virtual interface identified by
and . The parameter is the Router ID of the neighbor.
▫ Format no area virtual-link hello-interval
▫ Mode Router OSPF Config
12.7.19 area virtual-link retransmit-interval (OSPF)
This command configures the retransmit interval for the OSPF virtual interface on the virtual interface identified by and