PLANET WGS3-24240 - Manual (Page 204)

User’s Manual of WGS3-24000 / WGS3-24240
204
4.5.1.3 IP ACL Rule Configuration
Use these screens to configure the rules for the Access Control Lists created using the Access Control List Configuration screen.
What is shown on this screen varies depending on the current step in the rule configuration process. An ACL must first be
selected to configure rules for. The rule identification, and the 'Action' and 'Match Every' parameters must be specified next. If
'Match Every' is set to false a new screen will then be presented from which the match criteria can be configured.
Figure 4-5-3 ACL Rule Configuration
Ths is an Internet Protocol (IPv4) Subnet table. You can use this to quickly look up how your might need to define the scope of
the IP address filter for the IP ACL rules.
Filter Range IP Address IP Subnet Mask Wildcard Mask Setting Numb er of Hosts
Any 0.0.0.0 0.0.0.0 255.255.255.255 --
Class A 10.1.1.0 255.0.0.0 0.255.255.255 16777214
Class B 172.16.0.0 255.255.0.0 0.0.255.255 65534
Class C / 24 192.168.1.0 255.255.255.0 0.0.0.255 254
Class C / 25 192.168.1.0 255.255.255.128 0.0.0.127 126
Class C / 26 192.168.1.0 255.255.255.192 0.0.0.63 62
Class C / 27 192.168.1.0 255.255.255.224 0.0.0.31 30
Class C / 28 192.168.1.0 255.255.255.240 0.0.0.15 14
Class C / 29 192.168.1.0 255.255.255.248 0.0.0.7 6
Class C / 30 192.168.1.0 255.255.255.252 0.0.0.3 2
Single Host 192.168.1.100 255.255.255.255 0.0.0.0 1