PLANET WGS3-24240 - Manual (Page 377)

User’s Manual of WGS3-24000 / WGS3-24240
377
8.5.1.1 no bridge aging-time
This command sets the forwarding database address aging timeout to 300 seconds. In an IVL system, the [fdbid/all] parameter
is required.
▫ Format no bridge aging-time [fdbid | all]
▫ Mode Global Config
Forwarding Database ID - Fdbid (Forwarding database ID) indicates which forwarding database's aging timeout is being
configured. All is used to configure all forwarding database's agetime.
8.5.2 mtu
This command sets the maximum transmission unit (MTU) size (in bytes) for physical and port-channel (LAG) interfaces. For
the standard implementation, the range of is a valid integer between 1522-9216.
▫ Default 1522
▫ Format mtu <1522-9216>
▫ Mode Interface Config
8.5.2.1 no mtu
This command sets the default maximum transmission unit (MTU) size (in bytes) for the interface.
▫ Format no mtu
▫ Mode Interface Config
8.5.3 network javamode
This command specifies whether or not the switch should allow access to the Java applet in the header frame of the Web
interface. When access is enabled, the Java applet can be viewed from the Web interface. When access is disabled, the user
cannot view the Java applet.
▫ Default Enabled
▫ Format network javamode
▫ Mode Privileged EXEC
8.5.3.1 no network javamode
This command disallows access to the Java applet in the header frame of the Web interface. When access is disabled, the user
cannot view the Java applet.
▫ Format no network javamode
▫ Mode Privileged EXEC
8.5.4 network mac-address
This command sets locally administered MAC addresses. The following rules apply:
▫ Bit 6 of byte 0 (called the U/L bit) indicates whether the address is universally administered (b'0') or locally administered
(b'1').
▫ Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual address (b'0') or a group
address (b'1').