PLANET WGS3-24240 User Manual
Page 298
User’s Manual of WGS3-24000 / WGS3-24240
298
Object
Description
• Slot/Port
Select the router interface for which data is to be configured.
Configurable Data
Object
Description
• Advertise Mode
Select enable or disable from the pulldown menu. If you select enable, Router
Advertisements will be transmitted from the selected interface.
• Advertise Address
Enter the IP Address to be used to advertise the router.
• Maximum Advertise
Interval
Enter the maximum time (in seconds) allowed between router advertisements
sent from the interface.
• Minimum Advertise
Interval
Enter the minimum time (in seconds) allowed between router advertisements
sent from the interface.
• Advertise Lifetime
Enter the value (in seconds) to be used as the lifetime field in router
advertisements sent from the interface. This is the maximum length of time that
the advertised addresses are to be considered as valid router addresses by
hosts.
• Preference Level
Specify the preference level of the router as a default router relative to other
routers on the same subnet. Higher numbered addresses are preferred. You
must enter an integer.
• Submit button
Send the updated configuration to the switch. Configuration changes take effect
immediately. The changes will not be retained across a power cycle unless a
save is performed.