PLANET WGS3-24240 - Manual (Page 483)

User’s Manual of WGS3-24000 / WGS3-24240
483
12.2.24 show ip route summary
Use this command to display the routing table summary. Use the optional all parameter to show the number of all routes,
including best and non-best routes. To include only the number of best routes, do not use the optional parameter.
▫ Format show ip route summary [all]
▫ Mode Privileged EXEC
User EXEC
Connected Routes The total number of connected routes in the routing table.
Static Routes Total number of static routes in the routing table.
RIP Routes Total number of routes installed by RIP protocol.
BGP Routes Total number of routes installed by BGP protocol.
OSPF Routes Total number of routes installed by OSPF protocol.
Total Routes Total number of routes in the routing table.
12.2.25 show ip route preferences
This command displays detailed information about the route preferences. Route preferences are used in determining the best
route. Lower router preference values are preferred over higher router preference values. A route with a preference of 255
cannot be used to forward traffic.
▫ Format show ip route preferences
▫ Modes Privileged EXEC
User EXEC
Local This field displays the local route preference value.
Static This field displays the static route preference value.
OSPF Intra This field displays the OSPF Intra route preference value.
OSPF Inter This field displays the OSPF Inter route preference value.
OSPF Ext T1 This field displays the OSPF External Type-1 route preference value.
OSPF Ext T2 This field displays the OSPF External Type-2 route preference value.
OSPF NSSA T1 This field displays the OSPF NSSA Type-1 route preference value.
OSPF NSSA T2 This field displays the OSPF NSSA Type-2 route preference value.
RIP This field displays the RIP route preference value.
BGP4 This field displays the BGP-4 route preference value.
"
Note : The configuration of NSSA preferences is not supported in this release.