PLANET WGS3-24240 - Manual (Page 386)

User’s Manual of WGS3-24000 / WGS3-24240
386
recovery mode setting associated with the port is enabled.
▫ Format no snmp-server enable traps bcaststorm
▫ Mode Global Config
8.5.28 snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps are sent only if the Link Trap flag
setting associated with the port is enabled (see 'snmp trap link-status' command).
▫ Default Enabled
▫ Format snmp-server enable traps linkmode
▫ Mode Global Config
8.5.28.1 no snmp-server enable traps linkmode
This command disables Link Up/Down traps for the entire switch.
▫ Format no snmp-server enable traps linkmode
▫ Mode Global Config
8.5.29 snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is sent when a user logs in to the
terminal interface (EIA 232 or telnet) and there is an existing terminal interface session.
▫ Default Enabled
▫ Format snmp-server enable traps multiusers
▫ Mode Global Config
8.5.29.1 no snmp-server enable traps multiusers
This command disables Multiple User traps.
▫ Format no snmp-server enable traps multiusers
▫ Mode Global Config
8.5.30 snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification traps.
▫ Default Enabled
▫ Format snmp-server enable traps stpmode
▫ Mode Global Config
8.5.30.1 no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps.
▫ Format no snmp-server enable traps stpmode