PLANET WGS3-24240 - Manual (Page 248)

User’s Manual of WGS3-24000 / WGS3-24240
248
4.6.3 RIP
The Routing Information Protocol is used to specify how routers exchange routing table information. (See “RIP and RIP-2
Dynamic Routing Protocols” on Chapter “Advanced Topics”.) When RIP is enabled on this routing switch, it broadcasts RIP
messages to all devices in the network every 30 seconds, and updates its own routing table when RIP messages are received
from other routers. RIP messages contain both the IP address and a metric for each destination network it knows about, where
the metric indicates the number of hops from this device to the destination network.
4.6.3.1 RIP Configuration
Figure 4-6-9 RIP Configuration