PLANET WGS3-24240 - Manual (Page 49)

User’s Manual of WGS3-24000 / WGS3-24240
49
Configurable Data
Object Description
• Admin Mode Specifies if the Outbound Telnet service is Enabled or Disabled.
Default value is Enabled.
• Maximum Sessions Specifies the maximum number of Outbound Telnet Sessions allowed.
Default value is 5. Valid Range is (0 to 5).
• Session Timeout Specifies the Outbound Telnet login inactivity timeout.
Default value is 5. Valid Range is (1 to 160).
4.2.3.6 Serial Port
Use this page to define the parameters of console connectivity.
Figure 4-2-8 Serial Port Configuration
The configurable data are:
Object Description
• Serial Port Login
Timeout (minutes)
Specify how many minutes of inactivity should occur on a serial port connection
before the switch closes the connection.
Enter a number between 0 and 160: the factory default is 5. Entering 0 disables
the timeout.
• Baud Rate (bps) Select the default baud rate for the serial port connection from the pull-down
menu. You may choose from 1200, 2400, 4800, 9600, 19200, 38400, 57600, and
115200 baud.
The factory default is 115200 baud.
And the non-configurable data: