PLANET WGS3-24240 User Manual
Page 346
User’s Manual of WGS3-24000 / WGS3-24240
346
Configurable Data
Object
Description
• PIMSM Admin Mode
Select enable or disable from the pulldown menu to set the administrative status
of PIM-SM in the router. You must enable IGMP before enabling PIM-SM. The
default is disable.
• Join/Prune Interval
Enter the interval between the transmission of PIM-SM Join/Prune messages.
The valid values are from (10 to 3600 secs). The default value is 60.
• Data Threshold Rate
Enter the minimum source data rate in K bits/second above which the last-hop
router will switch to a source-specific shortest path tree. The valid values are
from (0 to 2000 K bits/sec) . The default value is 50.
• Register Threshold
Rate
Enter the minimum source data rate in K bits/second above which the
Rendezvous Point router will switch to a source-specific shortest path tree. The
valid values are from (0 to 2000 K bits/sec) . The default value is 50.
• Submit button
Send the updated configuration to the router. Configuration changes take effect
immediately. These changes will not be retained across a power cycle unless a
save is performed.
Only one multicast routing protocol could be enabled at one time. That means, for example, once
the PIM-DM admin mode is enabled, the user is not able to enable the DVMRP.
4.7.6.2 PIM-SM Global Parameters
Figure 4-6-79 PIM-SM Global Parameters