PLANET WGS3-24240 - Manual (Page 482)

User’s Manual of WGS3-24000 / WGS3-24240
482
Possible values are Enable or Disable.
12.2.23 show ip route
This command displays the routing table. The specifies the network for which the route is to be displayed and
displays the best matching best-route for the address. The specifies the subnet mask for the given . When
you use the longer-prefixes keyword, the and pair becomes the prefix, and the command displays the
routes to the addresses that match that prefix. Use the parameter to specify the protocol that installed the routes.
The value for can be connected, ospf, rip, static, or bgp. Use the all parameter to display all routes including best and
non-best routes. If you do not use the all parameter, the command only displays the best route.
"
Note : If you use the connected keyword for , the all option is not available because there are no best or
non-best connected routes.
▫ Format show ip route[{ [] | { [longer-prefixes] [] |
} [all] | all}]
▫ Mode Privileged EXEC
User EXEC
Route Codes Displays the key for the routing protocol codes that might appear in the routing table
output.
The show ip route command displays the routing tables in the following format:
Code IP-Address/Mask [Preference/Metric] via Next-Hop, Interface
The columns for the routing table display the following information:
Code The codes for the routing protocols that created the routes.
IP-Address/Mask The IP-Address and mask of the destination network corresponding to this route.
Preference The administrative distance associated with this route. Routes with low values are
preferred over routes with higher values.
Metric The cost associated with this route.
via Next-Hop The outgoing router IP address to use when forwarding traffic to the next router (if any) in
the path toward the destination
Interface The outgoing router interface to use when forwarding traffic to the next destination