PLANET WGS3-24240 - Manual (Page 213)

User’s Manual of WGS3-24000 / WGS3-24240
213
4.5.3 ACL Interface Configuration
Use these pages to apply the IP Based ACL or MAC Based ACL to specify interface.
Figure 4-5-10 ACL Interface Configuration
Configurable Data
Object Description
• Slot/Port Specifies list of all available valid interfaces for ACL mapping. All non-routing
physical interfaces and interfaces participating in LAGs are listed.
• Direction
Specifies the packet filtering direction for ACL.
Valid Directions
„ Inbound
• ACL Type
Specifies the type of ACL.
Valid ACL Types
„ IP ACL - Specifies list of all IP ACLs. This field is visible only if the user has
selected "IP ACL" as "ACL Type".
„ MAC ACL - Specifies list of all MAC ACLs. This field is visible only if the
user has selected "MAC ACL" as "ACL Type".
• Sequence Number An optional sequence number may be specified to indicate the order of this
access list relative to other access lists already assigned to this interface and
direction. A lower number indicates higher precedence order. If a sequence
number is already in use for this interface and direction, the specified access list
replaces the currently attached access list using that sequence number. If the
sequence number is not specified by the user, a sequence number that is one
greater than the highest sequence number currently in use for this interface and
direction will be used. Valid range is (1 to 4294967295).