31 snmptrap, 32 snmptrap ipaddr, 33 snmptrap mode – PLANET WGS3-24240 User Manual
Page 387: 34 telnet
User’s Manual of WGS3-24000 / WGS3-24240
387
▫
Mode
Global Config
8.5.31 snmptrap
This command adds an SNMP trap name. The maximum length of name is 16 case-sensitive alphanumeric characters.
▫
Default The default name for the six undefined community names is Delete.
▫
Format snmptrap
▫
Mode
Global Config
8.5.31.1 no snmptrap
This command deletes trap receivers for a community.
▫
Format no snmptrap
▫
Mode
Global Config
8.5.32 snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of name is 16 case-sensitive
alphanumeric characters.
▫
Format snmptrap ipaddr
▫
Mode
Global Config
IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries
using the same IP address, the first entry is retained and processed. All duplicate entries are
ignored.
8.5.33 snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to receive traps). Disabled trap
receivers are inactive (not able to receive traps).
▫
Format snmptrap mode
▫
Mode
Global Config
8.5.33.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able to receive traps).
▫
Format no snmptrap mode
▫
Mode
Global Config
8.5.34 telnet
This command regulates new telnet sessions. If sessions are enabled, new telnet sessions can be established until there are no
more sessions available. If sessions are disabled, no new telnet sessions are established. An established session remains