PLANET WGS3-24240 - Manual (Page 375)

User’s Manual of WGS3-24000 / WGS3-24240
375
8.2 Management VLAN Commands
8.2.1 network mgmt_vlan
This command configures the Management VLAN ID.
▫ Default 1
▫ Format network mgmt_vlan <1-4094>
▫ Mode Privileged EXEC
8.3 Dot1P Commands
8.3.1 classofservice dot1pmapping
This command maps an 802.1p priority to an internal traffic class for a device when in 'Global Config' mode. The number of
available traffic classes may vary with the platform. Userpriority and trafficclass can both be the range from 0-7. The command
is only available on platforms that support priority to traffic class mapping on a 'per-port' basis, and the number of available
traffic classes may vary with the platform.
▫ Format classofservice dot1pmapping
▫ Mode Global Config or Interface Config
8.3.2 show classofservice dot1pmapping
This command displays the current 802.1p priority mapping to internal traffic classes for a specific interface. The slot/port
parameter is required on platforms that support priority to traffic class mapping on a 'per-port' basis.
Platforms that support priority to traffic class mapping on a per-port basis:
▫ Format show classofservice dot1pmapping
Platforms that do not support priority to traffic class mapping on a per-port basis:
▫ Format show classofservice dot1pmapping
▫ Mode Privileged EXEC and User EXEC
8.3.3 vlan port priority all
This command configures the port priority assigned for untagged packets for all ports presently plugged into the device. The
range for the priority is 0-7. Any subsequent per port configuration will override this configuration setting.
▫ Format vlan port priority all
▫ Mode Global Config
8.3.4 vlan priority
This command configures the default 802.1p port priority assigned for untagged packets for a specific interface. The range for
the priority is 0-7
▫ Default 0
▫ Format vlan priority
▫ Mode Interface Config